Sample Configuration for Cisco Call Manager Express

VOIP setup and troubleshooting
Post Reply
Howard
Posts: 41
Joined: Sat Jan 07, 2006 10:07 am

Sample Configuration for Cisco Call Manager Express

Post by Howard » Tue Nov 20, 2007 10:29 pm

Hi All,

This is a sample configuration for Exetel VOIP service on a cisco 2821.

Code: Select all

voice service voip
 sip
!
voice class codec 1
 codec preference 1 g729r8
 codec preference 2 g729br8  <-- Exetel use this codec
 codec preference 3 g711alaw
 codec preference 4 g711ulaw
!
dial-peer voice 1 voip
 destination-pattern .T
 voice-class codec 1
 session protocol sipv2
 session target dns:sip1.exetel.com.au
 dtmf-relay rtp-nte
!
sip-ua
 authentication username 028205XXXX password XXXXXXXXXXXXXXX
 no remote-party-id
 registrar dns:sip1.exetel.com.au expires 3600
 sip-server dns:sip1.exetel.com.au
!
!
!
telephony-service
 max-ephones 10
 max-dn 20
 ip source-address 192.168.1.253 port 2000
 time-zone 10
 voicemail 121
 max-conferences 8 gain -6
 call-forward pattern .T
 transfer-system full-consult
 transfer-pattern .T
!
!
ephone-dn  1  dual-line
 number 028205XXXX
!
!
ephone  1
 device-security-mode none
 mac-address 0017.3122.593D
 type CIPC
 button  1:1
This configuration works fine for me using Cisco IP communicator on a PC in conjuction with a CISCO 2821 loaded with 12.4.15T IOS.

James
Exetel Staff
Posts: 1991
Joined: Mon May 09, 2005 10:27 pm

Post by James » Tue Nov 20, 2007 10:42 pm

Thank you for that Howard:)

Post Reply