Block sending of caller ID per call, SPA112

VOIP setup and troubleshooting
Post Reply
tbishop
Posts: 9
Joined: Mon Nov 14, 2011 7:12 am
Location: Bendigo, Victoria

Block sending of caller ID per call, SPA112

Post by tbishop » Tue Sep 17, 2013 1:16 pm

Sorry if this has been asked somewhere else, but I need to block sending caller ID, on a per call basis. Using a Cisco SPA112.
The VOIP DID was ported from PSTN so I can't disable it in the member facilities, and dialling *67 doesn't work (just gives engaged tone for all subsequent calls and requires config restore to rectify :shock: )
Any ideas?

User avatar
asankag
Exetel Staff
Posts: 77
Joined: Tue Jun 12, 2012 3:22 pm
Location: Sydney

Re: Block sending of caller ID per call, SPA112

Post by asankag » Tue Sep 17, 2013 2:09 pm

Hi mate,

It is not possible to block caller ID per call basis. As per with PSTN service it is applied for all calls (i.e. on or off). If you want to block your caller ID please PM me your service number and I will get it done for you.
---
Regards,
Asanka | L2 - VoIP Engineer

Post Reply