VoIP will not authenticate.

[adolph]

Hi,

I have received the email with the VOIP settings for my new ADSL2 Naked connection. I put all the settings in as described and I am getting an auth failure from my modem (Billion 7401 VGP-M).

Looking through the logs this is the error message: SIP Invalid Username/Password for phone XXXXXXXXXX

I have also tried connecting with my mobile phone using Fring and getting the same issue.

So the settings that I am using on my modem are below. From all the reading of documents and the fourms they appear to be correct.

Setting for Phone Port 1
- Registrar Address(or Hostname) 58.96.1.2
- Registrar Port: 5060
- Expire seconds: 3600
- User Domain/Realm: 58.96.1.2
- Outbound Proxy Address: 58.96.1.2
- Outbound Proxy Port: 5060

So at this point in time it looks like a problem with my user name and password, but since I have never had VOIP running on this modem before I am not ruling out a problem with the modem.

Has any one got there Exetel VOIP running with a Billion 7401 VGP-M?

Any help is much appreciated.

Regards,

Adolph

[outbush]

Hi,

I have received the email with the VOIP settings for my new ADSL2 Naked connection. I put all the settings in as described and I am getting an auth failure from my modem (Billion 7401 VGP-M).
Looking through the logs this is the error message: SIP Invalid Username/Password for phone XXXXXXXXXX

Do you have your settings correct?
Follow these....
http://www.exetel.com.au/voip_pdf/analogue.pdf
as per page 8

• Phone Number: VoIP Telephone Number (028205xxxx)
• Authentication Username: VoIP Telephone Number (028205xxxx)
• Authentication Password: Provided in Setup Email (eg. 1A2B3C4D)
• Confrim Password: Provided in Setup Email (eg. 1A2B3C4D)
• Display Name: VoIP Telephone Number (028205xxxx)

Save config, then sync now

* Hint: You may need to cancel your already created user profile and create another one.

[adolph]

Yes, I believe that I have all the settings correct. I have just triple checked them according to the document provide and all the settings seem to be good.

[adolph]

I have just reset the modem to factory defaults and reconfigured it and still no luck with VOIP

[VoIP Admin]

You will need to log into the User Facilities and get the password reset, looking at the posts above i suspect it to be a password issue.

Please let me know if you need help in resetting the password.

[adolph]

So I have reset the password and tested with the softphone and it appears to work. Will try it with my modem this evening.

Wishing that I had tried that 2 days ago!

Thanks for your help.

[adolph]

Plugged the new password in to the modem and it is all working.

Thanks for all the help guys.

Cheers