Looking for ideas/help.
* Connected 2 weeks ago to Exetel (formerly ADSL2 with Exetel): NBN50 (FTTN/VDSL), max sync ~52mbps, connect ~49mbps (860m of very good copper between modem and [micro]node);
* Netcomm NF18ACV from Exetel;
* corded vtech T1300 phone connected to modem port 1 through patch panel with cat6 about 10m, and 6ft phone cable; second phone, corded, telstra, connected also to port 1 using double adaptor near patch panel, also with cat6 about 15m (note this setup worked flawlessly before NBN ie ADSL2 with a billion router passing through POTS landline service to both phones);
* sip account / port 2 disabled in modem;
* Windows 10 Pro 1709.
Lots of the time (>>50%) the dial tone obtained on lifting the handset ought to but does not cease as I begin to dial the telephone number, so preventing me from making calls. When I do get to call out, at times the other end does not "hear" numbers I press in response to prompts.
I haven't been able to find a pattern as to when it works and when it doesn't. Sometimes disable/enable SIP account in the modem helps, sometimes not. Sometimes just repeated attempts to dial works (usually it takes many), sometimes not.
Line Coding(Trellis): On On
SNR Margin (0.1 dB): 68 65
Attenuation (0.1 dB): 258 0
Output Power (0.1 dBm): 123 81
Attainable Rate (Kbps): 52147 13703
Rate (Kbps): 49811 13703
codec ... ptime[ms] .... priority
G711U .... 20 ........... 1 (1-100) ... enabled
G711A .... 20 ........... 2 (1-100) ... enabled
all other codecs disabled
VOIP setup and troubleshooting
2 posts • Page 1 of 1
Thank you for contacting Exetel. We have sent out an email to your nominated email address on the account therefore kindly get back to us via the same email thread.